Why did the county name specific subdivisions here?
Because the risk was not uniform. During Harvey the county warned that Barker Reservoir water could affect several thousand homes and named Canyon Gate, several Cinco Ranch sections, Kelliwood and Willow Fork. Naming subdivisions rather than a ZIP reflects how the water behaved: it reached the lowest ground first and left higher streets dry.
About 6,824 Katy-area homes were destroyed or damaged, with many in Canyon Gate, the oldest and lowest part of Cinco Ranch. For a resident the practical lesson is that elevation within a subdivision matters more than the subdivision's name, and a neighbor two streets up may have an entirely different experience.
What does reservoir water do that rain water does not?
It stays. Rain that gets into a house usually recedes as the street drains, while water held in a flood-control basin can sit around and inside buildings for days. Contact time is what determines how deeply water penetrates framing, subfloor and insulation, and it changes the demolition decisions more than depth does.
It also arrives late and from an unexpected direction. Homes can take water after the rain has stopped, which catches people who have already decided they came through the storm. That is why a warning about a basin is worth acting on even when the sky has cleared.
What does a smaller storm look like here?
Hurricane Beryl in July 2024 brought down limbs and flooded some streets in the Katy and Fulshear area along with damaged homes. That is the more common event: wind that opens roofing or breaks a branch through a roof, and street water that comes in at a garage or a low threshold rather than across the whole house.
Those jobs are smaller and still not trivial. Street water is contaminated, so porous material at floor level comes out, and a roof opened by wind leaks with the next rain rather than during the storm, which is why a ceiling stain can appear a week after everyone has stopped thinking about the weather.
How is a long-submersion house dried?
Slowly, with measurement rather than estimation. After days of contact the water is in the framing, the bottom plates and the subfloor, not only on surfaces. Material that cannot be verified dry comes out, and what stays is dried with equipment and read again on each visit until the numbers hold.
Humidity makes that harder than it sounds. Gulf Coast air will push moisture back into a room that has only been aired out, so dehumidification runs alongside the air movers. Our structural drying page explains how the two work together and when the equipment comes out.