Water Extraction
Standing and trapped water is pumped and extracted from floors, carpet pad and wall cavities before drying equipment goes in.
The work covers river and bayou flooding, hurricane and tropical storm damage, slab and supply line leaks, water heater and appliance failures, drain and sewer backups, structural drying, humidity control and the licensed mold stages that sometimes follow. Call at any hour and describe where the water is coming from.
Fastest: call (833) 490-5225. Or send this and we call you back.
Water reaches a building in this county in several different ways, and each one changes the work. Floodwater carries silt and is handled as contaminated. A roof opening soaks attic insulation before it marks a ceiling. A cracked line under a slab can wet a floor for weeks before anything is visible. A freeze bursts the pipes that run through an unheated garage.
Whichever page matches your problem, the sequence is the same: stop the water, extract it, read the materials, dry to a target and keep a record. If you are not sure which service applies, call and describe what you can see. Nobody expects a homeowner to diagnose a water loss before reporting it.
Standing and trapped water is pumped and extracted from floors, carpet pad and wall cavities before drying equipment goes in.
Cleanup after river or bayou water enters a building, from contaminated extraction and silt removal through to dried and documented framing.
Hidden leaks are located with meter tests, acoustic equipment, thermal imaging and moisture mapping so that only the right section of floor or wall is opened.
Contained cleanup after a drain or sewer backup, with porous materials removed, surfaces cleaned and treated, and the structure dried to readings.
Water coming down from an attic or through a ceiling is traced to its source, wet insulation and ceiling board are dealt with, and the cavity is dried.
Water released by a pipe that froze and split is extracted, the wet wall and floor assemblies are opened where needed, and everything is dried to readings.
Water losses in apartment buildings, where one failure affects several units, shared assemblies and the common areas between them.
Equipment drying of framing, slab, cavities and finishes, measured each visit against an unaffected part of the same building.
Water that enters a slab home from outside at the threshold, garage, slab edge or penetration, and the drying of everything it reached on the way in.
Contained removal of mold-affected materials, treatment of what stays, correction of the moisture source and drying, under the Texas licensing framework.
The most contaminated class of water loss, where floodwater or sewage requires containment, removal of absorbent materials and verified cleaning before drying.
Cleanup and drying after a water heater leaks or fails, including attic installations where the water reaches the ceilings below.
Extraction and drying of carpet, pad, laminate, tile and wood laid over concrete, with the slab itself read before any floor is relaid.
Water loss work in offices, retail, medical, warehouse and mixed-use buildings, staged around occupancy and documented tenancy by tenancy.
Storm-driven water losses, from street and rainfall flooding to wind-opened roofs, handled under the rules for contaminated water where that applies.
The water damage side of a leak in plumbing under or within a concrete slab, from locating the surfacing point through to drying the concrete.
Measuring and lowering indoor humidity, whether after a water loss or as a standing condition in a closed building on this coast.
The interior half of a roof leak: tracing the route, dealing with wet insulation and ceiling board, and drying the assemblies the water passed through.
Water losses from washing machines, dishwashers, refrigerator lines and ice makers, including the slow ones that run behind a cabinet for months.
Moisture problems in the unconditioned spaces above and below a building, where condensation and ventilation faults matter more than leaks.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what service should cost.
Call the 24/7 line and say where the water is coming from. The crew matches the work to the source, whether that is floodwater, a slab leak, an appliance, a drain or the roof. You do not have to choose correctly before you call, and guessing wrong costs nothing.
Frequently. A heavy rain event that also backed water up through a floor drain is handled as flood water and contaminated drain water together. The category is settled on the walkthrough, and the steps for each are explained before the work starts.
Drying is what prevents mold, but once growth is established the size of the area decides what rules apply. Mold remediation covers the work, and when mold work needs a license explains the TX threshold and notification.
No. Water removal, controlled removal of ruined material and drying to a target reading are the scope. Plumbers, roofers and finish trades handle the repairs, and the drying record is useful to them because it shows where the water actually went.